How To Reset Zoeller Pump Alarm

How To Reset Zoeller Pump Alarm

In this article: 

  • How to reset Zoeller Pump Alarm?
  • How do I reset my Zoeller Pump?
  • How do I stop my Zoeller Battery Backup Sump Pump from beeping? 

Table of Contents

How To Reset Zoeller Pump Alarm?

You don’t require any mechanical knowledge to reset your Zoeller Pump Alarm. To reset the sump pump alarm: 

1. Locate the reset button on the control module. And this is how the reset button looks like:

2. Press the reset button for max. 3 times. And it will reset the alarm system.

If this method doesn’t work for you, just unplug the control module from the electrical outlet and leave the unit for 30 seconds. Then, reconnect the control module with an electric connection. I hope it will help you reset the pump alarm. 

How Do I Reset My Zoeller Pump?

Resetting a Zoeller Sump Pump is as simple as you reset the pump alarm. Just disconnect the sump pump from the electric connection for 30 seconds. Then, plug the sump pump again into the electric outlet and the pump has reset successfully. 

How Do I Stop My Zoeller Battery Backup Sump Pump From Beeping?

Before knowing the remedy, it’s indispensable to learn about the disease aka the reasons that cause the pump to make beeping.  

Primary Pump Is Not Operating

When your primary pump is not working, the battery backup pump will start and pump the water from the basement. 

You can easily determine whether the primary pump is running or not by keeping your hand on the discharge pipe of the primary pump. 

If you feel vibration, understand the primary pump is running. Otherwise, the battery backup pump is in operation. 

To resolve this issue, have the primary pump checked professionally. If needed, replace the primary pump with a new one. 

Power Outage

During a power outage, the battery backup pump will come into play. It will make a beeping noise to let you know that it’s in operation. Typically, you can operate the battery backup sump pump for 6-8 hours. 

When the electric power has been restored, the beeping noise will go off automatically. In short, you don’t need to take any corrective actions if the pump makes a sound during a power outage. 

Apart from these two reasons, there are several things to blame. For example, bad battery, low fluid, loose wire connections, and corroded wire terminals are also responsible for the beeping noise.

End-Note

Just press the reset button on the controller module for maximum 3 times and it will reset the Zoeller Pump Alarm. 

Alternatively, unplugging the control module from the electrical connection for 30 seconds will also help you reset the sump pump alarm. 

Try any of the two methods and have the pump alarm reset.

Read Also:

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *